ALLEN & HEATH xDR-16 Guide d'installation télécharger pdf

iLive M-DANTE Option Instructions 1 AP8340 issue 4

M-DANTE is one of several plug-in card options available from Allen &

Heath that may be fitted to iLive, GLD and ME Series products.

Dante

is a high performance, multi-channel, AVB ready industry

standard digital media transport system developed by Australian

company Audinate that runs over standard IP networks and can

distribute signals between iLive, computers and 3

party Dante

enabled equipment. Its main benefits are:

64 channel bi-directional audio plus control over CAT5

Uses standard off-the-shelf computer networking equipment

Easy to add, name, remove and rearrange devices

Secondary port for redundant connection option

Control port can bridge other control network over Dante

Very low latency

Direct connection to computer for multitrack recording

Dante Virtual Soundcard (DVS) software

Dante Controller software for setting up the network

Note The Allen & Heath M-DANTE card provides an interface to the

Dante network. The Dante ‘Brooklyn II’ hardware used and the software

required to set it up and record to computer is provided and supported

by Audinate. For further information or help on using Dante please refer

to the documentation and support at Audinate: www.audinate.com

M-DANTE is supplied with one Dante Virtual Soundcard licence to

enable a single computer. More can be purchased from Audinate if

required. The token below is needed to obtain your licence Id. Please

read the instructions provided within this guide.

Dante Virtual Soundcard Licence ID token:

Dante Option Card Publication AP8340

Fitting and Setup Guide

This guide applies to Dante Release 2 (firmware 3.6.4) or later.

This release adds dual redundancy and supports bridging of other control networks over

Dante. Please refer to the notes regarding differences with previous firmware 3.4.15.

Part number M-DANTE-A

Issue 2

Issue 4

1 2 3 4 5 6 ... 11 12

Résumé du contenu

Page 1 - Fitting and Setup Guide

iLive M-DANTE Option Instructions 1 AP8340 issue 4 M-DANTE is one of several plug-in card options available from Allen & H

Page 2 - REMOTE AUDIO 2

iLive M- DANTE Option Instructions 10 AP8340 issue 4 Setting up the network Your iLive M-DANTE cards, PC or Mac running Dante

Page 3

iLive M-DANTE Option Instructions 11 AP8340 issue 4 IP addressing As with any TCP/IP Ethernet network, each Dante devices inc

Page 4

iLive M- DANTE Option Instructions 12 AP8340 issue 4 Routing and clocking signals iLive Route signals to the 64 Dante channels on Por

Page 5

iLive M- DANTE Option Instructions 2 AP8340 issue 4 REMOTE AUDIO 2Port AREMOTE AUDIO 2Port BiDR10RAB2 moduleRAB2 moduleSurfacePort BPo

Page 6 - Secondary

iLive M-DANTE Option Instructions 3 AP8340 issue 4 Dante Virtual Soundcard (DVS) is a software application that turns your PC or Ma

Page 7

iLive M- DANTE Option Instructions 4 AP8340 issue 4 Dante Controller is a software application provided by Audinate which allows users t

Page 8 - Port B M-Dante Primary port

iLive M-DANTE Option Instructions 5 AP8340 issue 4 Release 1 – Firmware version 3.4.15 Release 2 – Firmware version 3.6.4

Page 9 - Gigabit Switch

iLive M- DANTE Option Instructions 6 AP8340 issue 4 Connections and indicators Firmware version 3.6.4 Primary Port Gigabit Ethern

Page 10 - Setting up the network

iLive M-DANTE Option Instructions 7 AP8340 issue 4 Linking consoles – Single CAT5 cable Consoles can be linked for FOH/Monitor op

Page 11

iLive M- DANTE Option Instructions 8 AP8340 issue 4 Connecting to a single device This example shows connection to a PC or Mac for multi

Page 12

iLive M-DANTE Option Instructions 9 AP8340 issue 4 FOH/Monitor linking through a switch This example shows two iLive systems using

Commentaires sur ces manuels

Pas de commentaire

ALLEN & HEATH xDR-16 Guide d'installation

Naviguer en ligne ou télécharger Guide d'installation pour Non ALLEN & HEATH xDR-16. ALLEN & HEATH xDR-16 Setup guide Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels