ALLEN & HEATH XONE V6 Guide de l'utilisateur télécharger pdf (Page 13)

XONE:V6 User Guide 13

Headphones Controls

The DJ headphones is sourced from the booth mix and switched cue system.

Headphone sockets are provided on both the front and rear panels.

Tone control This combines the LF and HF equaliser into one, easy to use

control. At centre position the frequency response is flat. Turning clockwise

boosts the high frequencies while cutting the lows. Turning anti-clockwise

boosts the lows while cutting the highs. Use this to check the frequency make-

up of the music you are cueing in the headphones.

Cue / Mix This control balances the level of cue signal and booth (music)

signal in the headphones. Fully anti-clockwise, only cue signal is routed. Fully

clockwise, only booth mix is routed. At centre position, equal cue and booth

signal is mixed together. Use the control when auditioning new tracks and

experimenting with how they may sound when added to the mix.

Phones level Controls the overall level of the headphones. It ranges from

fully off to maximum volume.

Headphones are available with different impedance specification, typically

between 8 and 600 ohms. The XONE:V6 is designed to operate with

headphones in the range 30 to 600 ohms. For best performance we

recommend the high quality 70 or 100 ohm type popular with top DJs.

Important Note about Hearing: To avoid damage to your

hearing do not operate any sound system at excessively high volume. This

also applies to any close-to-ear monitoring such as headphones. Continued

exposure to high volume sound can cause frequency selective or wide range

hearing loss. Make sure that your system complies with any venue sound level

and noise regulations which may apply.

PHONES

MIX

CUE

TONE

CUE/MIX

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 41 42

Pas de commentaire

ALLEN & HEATH XONE V6 Guide de l'utilisateur Page 13